PT-RZ470
Home > Business Product > Professional Display System > Projector > Installation > PT-RZ470
PT-RZ470
Fixed Installation Laser Projector
Entry Solid Shine LED/laser combined projector Ideal for use in education, corporate or digital signage.
This new light source requires no maintenance for approximately 20,000 hours.* In many cases, this means no maintenance until your next refresh cycle. Naturally, there are no lamp burnout problems during use, so reliability is further increased. There is also no filter to clean due to carefully engineered sealed optics.
As a consequence, running cost is dramatically lowered because of the savings on lamp costs, maintenance labor and hassle of stocking lamps.
- LED/ Laser 1-chip DLP, 3500 lumens, Full HD
- LED/Laser light source enables up to 20,000 hours of maintenance free usage
- DIGITAL LINK connectivity
- System expandability with portrait mode installation capability and edge Blending
- 20,000:1 contrast ratio
Power supply | 100-240 V AC, 5.2-2.0 A, 50/60 Hz |
Power consumption | 460 W (470 VA) (250 W with LIGHT POWER set to NORMAL, 200 W with LIGHT POWER set to Ecosave1, 178 W with LIGHT POWER set to Ecosave2. 0.5 W with STANDBY MODE set to ECO, 8 W with STANDBY MODE set to NORMAL) |
DLP™ chip Panel size | 16.5 mm (0.65 in) diagonal (16:9 aspect ratio) |
DLP™ chip Display method | DLP™ chip x 1, DLP™ system |
DLP™ chip Pixels | 2,073,600 (1,920 x 1,080) x 1, total of 2,073,600 pixels |
LENS | Manual zoom (2.0x), manual focus, F 2.0 – 3.4, f 21.5 – 43.0 mm |
Throw ratio | 1.46-2.94:1 |
Light source | LED/Laser-combined (R, B: LED; G: Laser diode) |
Screen size | 1.02 – 7.62 m (40 – 300 inches) diagonally, 16:9 aspect ratio |
Brightness | 3,500 lumens |
Center-to-corner uniformity | 90% |
Contrast | 20,000:1 (full on/off) |
Resolution | 1,920 x 1,080 pixels (Input signals that exceed this resolution will be converted to 1,920 x 1,080 pixels.) |
Scanning Frequency (HDMI/DVI-I (Digital)) | fH: 27-100 kHz, fv: 24-120 Hz, dot clock: 25-162 MHz |
Scanning Frequency (DVI-I (Analog)/RGB) | fH: 15-100 kHz, fv: 24-120 Hz, dot clock: 162 MHz or lower |
Scanning frequency YPBPR (YCBCR) | fH: 15.75 kHz, fV: 60 Hz [480i(525i)] fH: 15.63 kHz, fV: 50 Hz [576i(625i)] fH: 31.50 kHz, fV: 60 Hz [480p(525p)] fH: 31.25 kHz, fV: 50 Hz [576p(625p)] fH: 45.00 kHz, fV: 60 Hz [720(750)/60p] fH: 37.50 kHz, fV: 50 Hz [720(750)/50p] fH: 33.75 kHz, fV: 60 Hz [1035(1125)/60i] fH: 33.75 kHz, fV: 60 Hz [1080(1125)/60i] fH: 28.13 kHz, fV: 50 Hz [1080(1125)/50i] fH: 28.13 kHz, fV: 25 Hz [1080(1125)/25p] fH: 27.00 kHz, fV: 24 Hz [1080(1125)/24p] fH: 27.00 kHz, fV: 48 Hz [1080(1125)/24sF] fH: 33.75 kHz, fV: 30 Hz [1080(1125)/30p] fH: 67.50 kHz, fV: 60 Hz [1080(1125)/60p] fH: 56.25 kHz, fV: 50 Hz [1080(1125)/50p] |
Scanning Frequency (Video) | fH: 15.75 kHz, fV: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60]; fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM] |
Optical axis shift | Vertical: +73%, -48% (manual), Horizontal: +27%, -35% (manual) |
Keystone correction range | Vertical: ±40° |
Installation | Ceiling/floor, front/rear |
Terminals HDMI IN | HDMI 19-pin x 1 (Deep Color, compatible with HDCP); 480p(525p), 576p(625p), 720(750)/60p, 720(750)/50p, 1080(1125)/60i, 1080(1125)/50i, 1080(1125)/25p, 1080(1125)/24p, 1080(1125)/24sF, 1080(1125)/30p, 1080(1125)/60p, 1080(1125)/50p, VGA(640 x 480) – WUXGA(1,920 x 1,200), compatible with non-interlaced signals only, dot clock: 25-162 MHz, audio signal: linear PCM (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz) |
Terminals DVI-I IN | DVI-I 29-pin x 1 |
Terminals DVI-I IN Digital | DVI 1.0 compliant, HDCP compatible, for single link only; 480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p, 1080/24sF, 1080/25p, 1080/30p, 1080/60p, 1080/50p, VGA(640 x 480) – WUXGA(1,920 x 1,200), compatible with non-interlaced signals only, dot clock: 25-162 MHz |
Terminals DVI-I IN RGB | R: 0.7 Vp-p, 75 ohms; G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms; B: 0.7 Vp-p, 75 ohms; HD/VD, SYNC: TTL, high impedance, positive/negative automatic; NOTE: HD/SYNC, and VD terminals do not accept tri-level sync signals. |
Terminals DVI-I IN Y, PB, PR (Y, CB, CR) | Y: 1.0 Vp-p (including sync signal), PB/PR (CB/CR): 0.7 Vp-p, 75 ohms |
Terminals COMPUTER (RGB) IN | D-sub HD 15-pin (female) x 1 |
Terminals COMPUTER (RGB) IN R, G, B | R: 0.7 Vp-p, 75 ohms; G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms, B: 0.7 Vp-p, 75 ohms; HD/VD, SYNC: TTL, high impedance, positive/negative automatic; NOTE: HD/SYNC, and VD terminals do not accept tri-level sync signals. |
Terminals COMPUTER (RGB) IN Y, PB, PR (Y, CB, CR) | Y: 1.0 Vp-p (including sync signal), PB/PR (CB/CR): 0.7 Vp-p, 75 ohms |
Terminals VIDEO IN | RCA pin x 1, 1.0 Vp-p, 75 ohms |
Terminals AUDIO IN | M3 (L, R) x 1, 0.5 Vrms |
Terminals AUDIO OUT | M3 (L, R) x 1 (monitor out: 0-1.8 Vrms, variable) |
Terminals SERIAL IN | D-sub 9-pin (female) x 1 for external control (RS-232C compliant) |
Terminals LAN/DIGITAL LINK | RJ-45 x 1 for network and DIGITAL LINK (video/audio/network/serial control) connection, 100Base-TX, compatible with PJLink™, HDCP compatible, Deep Color compatible, 480p(525p), 576p(625p), 720(750)/60p, 720(750)/50p, 1080(1125)/60i, 1080(1125)/50i, 1080(1125)/25p, 1080(1125)/24p, 1080(1125)/24sF, 1080(1125)/30p, 1080(1125)/60p, 1080(1125)/50p, VGA(640 x 480) – WUXGA(1,920 x 1,200), compatible with non-interlaced signals only, dot clock: 25-162 MHz |
Terminals 3D SYNC OUT | Mini DIN 3-pin x 1, for 3D transmitter connection |
Power cord length | 3.0 m (9 ft 10 in) |
Cabinet materials | Molded plastic |
Dimensions (W x H x D) | 455 x 137 x 415 mm (17-29/32 x 5-13/32 x 16-11/32 inches) (lens incuded) |
Weight | Approx. 11.0 kg (24.3 lbs) |
Operation noise | 35 dB (LIGHT SOURCE MODE: NORMAL), 29 dB (LIGHT SOURCE MODE: LOW) |
Operating temperature | 0℃ – 45℃ (32℉ – 113℉) |
Operating humidity | 20% – 80% (no condensation) |
Technology | 1-chip DLP LED/ Laser |